Collection Instructions

Specimen Collection: Swab or Urine

Container(s): Alinity m Multi-Collect tube

1. Specimens should be obtained with a swab using a speculum moistened with sterile warm water to facilitate collection.
2. Lubricants other than water should not be used since they can be toxic to the organism.
3. Discard disposable transfer pipette; it is not required for endocervical swab specimen collection
4. Remove the sterile swab from the wrapper, taking care not to touch swab tip or lay it down on any surface
5. Insert the white tip of the specimen collection swab into the endocervix canal.
6. Gently rotate the swab for 15 – 30 seconds to ensure adequate sampling
7. Withdraw the swab, carefully
8. Handle the cap and tube carefully to avoid contamination, including the outside of the transport tube and cap. If necessary, change gloves.
9. Unscrew the transport tube cap and immediately place the specimen collection swab into the transport tube so that the white tip is down.
10. Carefully break the swab at the scored line on the shaft; use care to avoid splashing the contents
11. Recap the transport tube. Ensure the cap seals tightly.
12. Label the transport tube with sample ID, including date and time of collection.
13. Transport to lab within 24 hours at room temperature or 14 days refrigerated.

Container(s): Sterile urine cup (with lid) or Alinity m multicollect sample kit

Preferred Volume to Collect: 30.0 mL
Minimum Volume to Collect: 10 mL if sterile cup is transported to lab; to fill line of Alinity m multicollect tube if transferred in office.

Aliquot: Yes - Transfer urine to Alinity m multicollect tube in office is preferred.

Collection Instructions:

1. First void ("dirty") urine is included in this collection, this is collected before a UA specimen, if both are needed.
2. Do not cleanse the genital area prior to specimen collection.
3. Patient should not have urinated for at least one hour prior to sample collection.
4. Follow directions above to obtain a first void urine specimen.
5. Discard specimen collection swab, it is not required for urine specimen collection.
6. Unscrew the transport tube cap, taking care not to spill the transport buffer within.
7. Handle the cap and tube carefully to avoid contamination.
8. Use the plastic transfer pipette to transfer urine from the collection cup into the transport tube until the liquid level in the tube falls within the clear fill window of the transport tube label or else a new specimen should be collected.
9. Do not overfill. Slightly more than one full squeeze of the transfer pipette bulb may be required to transfer the necessary volume of urine specimen.
10. Recap the transport tube carefully. Ensure the cap seals tightly.
11. Label the transport tube with sample identification information, including date of collection. Take care not to obscure the fill window on the transport tube.

Transport Temperature:  Ambient (room temperature) or Refrigerated

NOTE:  Failure to collect a urine specimen, including the first part of the voiding, may decrease the sensitivity of this test. If the specimen cannot be delivered to the laboratory within a few hours after collection it should be stored and refrigerated until it can be delivered. Specimen must be received in laboratory for analysis within 24 hours of collection.